What is the whole process of using diaphragm filter press in sludge?

The diaphragm filter press is an industrial equipment with excellent characteristics. I must understand the diaphragm filter press. Do you know the whole process of applying diaphragm filter press in sludge? Let me introduce you in detail!

After entering the sludge, the high-pressure water is introduced into the diaphragm plate of the diaphragm filter press by the diaphragm pump, and the sludge is squeezed and dried according to the supporting force of the diaphragm. The leachate is discharged according to the filter cloth of the filter press, and the solid chemical substances are blocked by the filter cloth of the filter press, resulting in dry substances with low water content.

The water content of sludge entering the diaphragm filter press should not be too high. Because the high water content of sludge will not only improve the specification of sludge settlement structure and the difficulty coefficient of sludge settlement, but also continue to increase the total flow of sludge. If the magnetic pump should feed within the specified time period, the output power of the magnetic pump will increase. Increase function loss. Generally speaking, the water content of sludge before entering the filtration unit shall not be higher than 98%.

Most of the solid sludge volume solved by the diaphragm filter press has not changed, because the volume of the filter chamber is numerical. Taking the filter unit with a total area of 800m2 as an example, the volume of the filter unit is 14m3. In one feeding process, the allowable range of specific solid sludge volume is 85%-99% of the solid sludge volume in the design scheme, but it can not be less than the smaller value.

Since the diaphragm filter press is operated after feeding, the expansion of the diaphragm is mainly based on the introduction of high-pressure water into the diaphragm plate, and the sludge in the middle of the diaphragm plate is squeezed and dried according to the supporting force of the diaphragm. If the sludge volume in the middle of the diaphragm fails to meet the design value, the area in the middle of the diaphragm will increase. Under the pressure of high-pressure water, it is very easy to squeeze the diaphragm and spray high-pressure water, resulting in safety accidents.

The diaphragm of the diaphragm filter press is generally composed of thermoplastic rubber, glass fiber filament, glass fiber cloth and polypropylene, which has the function of heat resistance and high pressure resistance. If the reduced working pressure does not exceed a certain value, the membrane will not be easy to swell or open, thus endangering the actual effect of sludge dewatering. Therefore, the reduced working pressure should not be less than 1MPa.